Engine Automotive

Until new additive technology came along to reduce oil burning, oil leaks, valve tap, power loss, and fuel waste problems, the remedy took a $3000+ repair to do the fix.

--- Not anymore, thanks to what I call my Mega Power Worn Motor Oil Change Treatment.

Before I tell you how this mechanic-in-a-can product stops those problems, let explain what causes them.

Oil burning is caused by stuck-closed and sticky piston rings, piston wear, valves stem wear, and valve stem seal wear.

Those conditions makes it easy for engine oil to be sucked into the combustion cycle. Over time, the motors oil level drops two to four quarts of oil, as a result of this "siphoning off" of your motors oil.

Other negative problems begin. The first of which is that much more combustion can slip pass stuck or sticky piston rings - and worn pistons, leaving less combustion amounts to push the piston down. It takes more fuel burning to make up for this loss - and this lower fuel economy averages.

That escaped combustion - slips pass the pistons and drenches the lower park of the motor, and its oil with hundreds of degrees hot, acid-loaded combustion gases.

This creates massive amounts of oil-breakdown sludge. That starts valve taps and worn engine sounds. Excessive wear begins. The blackest oil you ever seen shows up on your dip stick. Seals dri-out, causing oil leaks all over your underside, and driveway.

The Mega Power Worn Motor OIl Change begins a week earlier, to start undoing the causes of oil consumption problems. That is when 3 of the six products are installed. One in the fuel tank, one into the air intake/vacuum side, and one is added to the oil. Driving helps the chemical process during the week.

The motor will begin to run great again, and oil burning will subside as the rings, valves, and sludge is removed.

A week later, the 3 remaining products are use just before and after the oil change.

By inventive use of different cleaners, penetrating oils, friction modifiers, oil stabilizers, and coating additives, the motor will chemically be "overhauled out of a can!

These 6 different products in the "kit," costing about the same price as that of a good oil change, makes any high mileage, older motor run like near-brand-new in less than an hour. Then stay that way indefinitely, with minor touch-ups at each oil change. The oil will now stay clean up to 6000 miles. Oil consumption will be minimal again. I have this method in my older vehicles, enjoying trouble-free driving, for an extra 50,000 -100,000 miles.